Automatic armature slot wedge inserter

Outside Dimension

910*880*1300(L*W*H)mm

Equipment Weight

250 Kg

Motor Power

0.75 Kw

Work Voltage

380 VAC

Work Air Pressure

0.4-0.6 hMp

Manufacturing Product

Motor Rotor Insulated Paper

Rotor O.D. Range

φ20-φ55

Length of Insulation Paper

15-60 mm Adjustable

(MAX) Width of wedge

25 mm

Rotor Slot number

8-24 slots

Work procedure

Feeding-install fixture-plug in discharge

Fixture

Pneumatic Mechanical Fixture

Feeding form

Automatic

Lubricant form

Grease lubrication

Malfunction

Check

A．Equipment not run even press start button

n Power and air supply

n Make sure all input signal from sensor are correct, travel switch (X10) is pressed, no signal from counter sensor (X2), push bar protector (X7) and no paper sensor(x6) and full feeding (X4). Also, there is signal from the mechanic hand (X0) and magnetic sensor (X1) of small cylinder.

n Brake is power off or not

n The feeding sensor(X3) should have signal if there is rotor on the guide way.

n Check cylinder and air pipe, make sure the pressure is between 0.4 and 0.6MPa

B. Fail to feed paper

n Check whether the paper is jammed in the feeding or discharging part, whether the upper press wheel is down pressed

C. No action or improper action in big cylinder

n Make sure the air pressure is 0.4 -0.6MPa

n Check whether the magnetic valve is functional.

n Adjust the release valve of feeding cylinder to 0.3 Mpa

D. Incorrect work indexing

n Adjust indexing screw

E. No action in small cylinder

n Check whether the mechanical valve is down pressed.

F. The position is not correct after reset

n Adjust the counter sensor screw and make sure it is on the right position after reset.

G. Paper jam

n If it was blocked in the forming tooling, the equipment would stop because of the protective switch on duty. If it was blocked behind the upper press wheel, press the stop button, now the mechanical hand still hold the rotors, press the single/automatic button to adjust it to manual, the mechanical hand will release the rotor, then take out the paper, and reset, adjust the button to automatic, and start the equipment.